Sprinkler System Not Working in Calgary? Common Causes and Fixes 2026

When a Calgary sprinkler system stops working mid-season, the cause is almost always one of five things. This guide walks you through each one โ€” how to identify it, and whether it requires a professional repair or a DIY fix.

Common Reasons Sprinklers Stop Working โ€” Calgary Diagnosis Guide

Problem Symptoms Likely Cause Fix Cost
No zones run Controller shows program, nothing activates Master valve, main shutoff, or controller fault Check shutoff is open, check master valve wiring $60-$280
One zone does not run All other zones fine, one zone silent Solenoid failure, broken wire, or stuck valve Solenoid replacement or wire repair $60-$160
Wet spot when system is off Soggy patch that does not dry Underground pipe break or valve not closing Leak detection + pipe repair $150-$500
Low pressure on a zone Heads barely pop up, poor coverage Partial blockage, too many heads, line restriction Flush filter, reduce head count, or add zone $60-$300
Controller shows error Short circuit warning, zone fault Wiring short, damaged solenoid, controller failure Disconnect zones one-by-one to isolate fault $80-$550
Why do Calgary sprinkler systems fail in July?

July failures are most often solenoid failures (heat + continuous cycling stresses the coil), pipe breaks from mowing damage, or controller malfunctions. Call J.G. Irrigation for same-week diagnosis: 587-433-4795.